LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1265 (HVAC - Climate Control System) >> Removal And Installation >> Blower Motor Resistor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the glove compartment.
  2. Disconnect the blower motor resistor electrical connector.
  3. Remove the 2 blower motor resistor screws.
    • To install, tighten to 3 Nm (27 lb-in).
  4. Remove the blower motor resistor.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals