LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1251 (Accessory Drive System - 2.5L (Hybrid)) >> Removal And Installation >> Accessory Drive Belt Tensioner >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE BELT .
  2. Depower the vehicle high voltage electrical system. For additional information, refer to HYBRID SERVICE DISABLE PROCEDURES .
  3. Disconnect the 2 vehicle high voltage electrical system electrical connectors.
    • Detach the vehicle high voltage electrical system electrical connector pin-type retainer from the accessory drive belt tensioner.
    4. NOTE: The accessory drive belt tensioner must be replaced as a complete unit.
  4. Remove the 3 bolts and the accessory drive belt tensioner.
    • To install, tighten to 25 Nm (18 lb-ft).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals