LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1250 (Accessory Drive System - 3.0L (4V)) >> Removal And Installation >> Accessory Drive Belt Tensioner >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the pin-type retainer, 5 bolts and the RH lower splash shield.
    • To install, tighten to 9 Nm (80 lb-in).
  3. Rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
  4. Remove the 3 bolts and the accessory drive belt tensioner.
    • To install, tighten to 25 Nm (18 lb-ft).
    5. NOTE: Refer to the illustration for correct drive belt routing.
    Fig 1: Identifying Accessory Drive Belt Tensioner
    G06096657Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals