Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the pin-type retainer, 5 bolts and the RH splash shield.
- To install, tighten to 9 Nm (80 lb-in).
Using the hex feature, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the coolant pump pulley.
- Remove the accessory drive belt from the engine.
  
  Fig 1: Removing Accessory Drive Belt From Coolant Pump Pulley
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.