LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1245 (Information System And Entertainment System) >> Removal And Installation >> Universal Serial Bus (USB) Cable and Port >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The original equipment Universal Serial Bus (USB) port and cable is part of the wiring harness. It can only be serviced by overlaying a new USB  port and cable.
  1. Remove the transmission selector level bezel by pulling straight up.
    2. NOTE: Open the floor console storage bin door.
  2. Remove the floor console finish panel by pulling straight up.
    • Disconnect the electrical connector, if necessary.
  3. Remove the center instrument panel lower panel by pulling straight back.
    • Disconnect the electrical connectors.
  4. Remove the USB  cable and port.
    • Disconnect the cable from the Accessory Protocol Interface Module (APIM).
    • Cut the USB  port and cable ends and secure them to prevent NVH concerns.
  5. To install, reverse the removal procedure.
    • Secure the new USB  port and cable, as necessary, to prevent NVH concerns.
scientia non olet · About LEMON Manuals