LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1245 (Information System And Entertainment System) >> Removal And Installation >> Antenna Cable - Satellite Radio >> Removal >> Upper cable

Upper cable

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the RH A-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Remove the RH sun visor. For additional information, refer to Headliner - Exploded View in INTERIOR TRIM AND ORNAMENTATION .
  3. Lower the front of the headliner enough to gain access to the satellite radio antenna electrical connector.
    • Disconnect the satellite radio antenna electrical connector.
  4. Remove the RH instrument panel side finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
    • Disconnect the upper-to-lower satellite radio antenna electrical connector.

    Lower cable 

  5. Remove the RH Instrument panel side finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
    • Disconnect the upper-to-lower satellite radio antenna electrical connector.
  6. Remove the glove compartment. For additional information, refer to Instrument Panel - Exploded View in INSTRUMENT PANEL AND CONSOLE .
  7. Remove the ACM  . For additional information, refer to AUDIO CONTROL MODULE (ACM) .
    • Disconnect the lower satellite radio antenna electrical connector from the ACM  .

    All cables 

  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals