LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1245 (Information System And Entertainment System) >> Diagnosis And Testing >> Information and Entertainment System >> Pinpoint Tests >> Pinpoint Test AA: DTC U0140 Or DTC U0140:00 >> Pinpoint Test Aa: DTC U0140 Or DTC U0140:00

Pinpoint Test Aa: DTC U0140 Or DTC U0140:00

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. AA1 CHECK FOR LOST COMMUNICATION DTCs 
    • Ignition ON.
    • Clear continuous DTCs from all modules.
    • Ignition OFF.
    • Ignition ON.
    • Wait at least 10 seconds.
    • Retrieve all continuous DTCs from all modules.
    • Is DTC U0140 or DTC U0140:00 set in any audio system module? 
    • Yes:  GO to AA2  .
    • No:  The system is operating correctly at this time. The DTC may have been set due to an intermittent fault condition in the network wiring.
  2. AA2 CHECK FOR BATTERY VOLTAGE OUT-OF-RANGE DTCs 
    • Carry out the self-test for the following modules:
      • ACM 
      • APIM 
      • FCIM 
      • FDIM 
      • GPSM 
      • SJB 
    • Is DTC B1317, B1318, U3003:16 or U3003:17 recorded in any module? 
  3. AA3 CHECK FOR DTC U0140 OR DTC U0140:00 SET IN MULTIPLE MODULES 
    • Review the recorded results from the self-test.
    • Is DTC U0140 or DTC U0140:00 set in more than one audio system module? 
    • Yes:  GO to AA4  .
    • No:  If there is an observable symptom, GO to SYMPTOM CHART - GENERAL AUDIO SYSTEM  to diagnose the observed symptom.

      CHECK the MS-CAN  wiring between the SJB  and the module in question for an intermittent fault.

  4. AA4 CHECK FOR CORRECT SJB OPERATION 
    • Ignition OFF.
    • Disconnect the SJB  connector.
    • Check for:
      • corrosion
      • damaged pins
      • pushed-out pins
    • Connect the SJB  connector and make sure it seats correctly.
    • Operate the system and determine if the concern is still present.
    • Is the concern still present? 
    • Yes:  INSTALL a new SJB  . REFER to MULTIFUNCTION ELECTRONIC MODULES . CLEAR all continuous DTCs. TEST the system for normal operation.
    • No:  The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR all continuous DTCs. REPEAT the self-test for the module(s) that set DTC U0140 or DTC U0140:00.
scientia non olet · About LEMON Manuals