LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1216 (Information Center - Instrumentation, Message Center And Warning Chimes) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AN: The Headlamps On Warning Chime Is Inoperative >> Pinpoint Test An: The Headlamps On Warning Chime Is Inoperative

Pinpoint Test An: The Headlamps On Warning Chime Is Inoperative

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. AN1 CHECK THE SAFETY BELT WARNING CHIME OPERATION 
    • Ignition OFF.
    • Ignition ON.
    • Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.
    • Does the safety belt warning chime operate for approximately 6 seconds? 
    • Yes:  GO to AN2  .
    • No:  INSTALL a new IC  . REFER to INSTRUMENT CLUSTER (IC) . TEST the system for normal operation.
  2. AN2 CHECK THE EXTERIOR LAMPS OPERATION 
    • Ignition OFF.
    • Place the headlamp switch in the PARKING LAMPS or HEADLAMP ON position.
    • Do the headlamps or parking lamps operate? 
  3. AN3 CHECK THE DOOR AJAR WARNING INDICATOR OPERATION 
    • Ignition ON.
    • Open then close the LH front door while observing the door ajar warning indicator.
    • Does the door ajar warning indicator operate correctly? 
scientia non olet · About LEMON Manuals