LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1210 (Interior Trim And Ornamentation) >> Removal And Installation >> Door Trim Panel - Rear >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: LH side shown in illustration, RH side similar.
  1. Open and remove the door handle finish panel.
    Fig 1: Locating Door Handle Finish Panel
    G06099549Courtesy of FORD MOTOR CO.
  2. Remove the door handle screw.
    Fig 2: Locating Door Handle Screw
    G06099550Courtesy of FORD MOTOR CO.
  3. Remove the door pull cup screw cover.
  4. Remove the door pull cup screw.
  5. Remove the 3 door trim panel screws.
  6. Remove the door trim panel.
    • Pull outward and then upward on the door trim panel.
    • Disconnect the electrical connector.
  7. Remove the door handle from the door trim panel.
    • Press the 2 retaining tabs while pushing the door handle from the door trim panel.
    • Remove the door handle from the door trim panel by pulling it back through the door trim panel.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals