LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1175 (Accessory Drive System - 3.5L) >> Removal And Installation >> Accessory Drive Belt Tensioner >> Removal

Accessory Drive Belt Tensioner: Removal

WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Working from the top of the vehicle, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the generator pulley.
  3. Remove the 4 screws and position the RH fender splash shield aside.
    Fig 1: Locating RH Fender Splash Shield Screws
    G06257214Courtesy of FORD MOTOR CO.
  4. Remove the 6 pin-type retainers and the RH splash shield.
  5. Remove the 3 bolts and the accessory drive belt tensioner.
scientia non olet · About LEMON Manuals