LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1154 (Vehicle Dynamic Systems) >> Removal And Installation >> Wheel Speed Sensor - Rear >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the wheel speed sensor electrical connector.
  3. Disconnect the wheel speed sensor harness clips.
  4. Remove the rear wheel speed sensor bolt, spacer and the sensor.
    • To install, tighten to 25 Nm (18 lb-ft).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals