Removal And Installation
WARNING: This page is about a different car, the 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | 9341 | Inertia fuel shutoff (IFS) switch |
| 2 | N611043 | Bolts |
| 3 | - | Electrical connector (part of 14A200) |
- Remove the RH cowl side trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
- Disconnect the inertia fuel shutoff (IFS) switch electrical connector. Remove the bolts and IFS switch.
- To install, tighten to 2 Nm (18 lb-in).
- To install, reverse the removal procedure.
CAUTION:
Do not over tighten the fasteners or damage to the switch will occur.