LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1143 (Electronic Engine Controls - Diesel Engine) >> Removal And Installation >> Camshaft Position (CMP) Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Turn the ignition switch to the OFF position.
    3. NOTE: The camshaft position (CMP) sensor is located behind the power steering pump.
  3. Disconnect the CMP sensor electrical connector.
  4. Remove the bolt, the CMP sensor and discard the O-ring seal.
    • To install, tighten to 13 Nm (10 lb-ft).
    5. NOTE: Apply clean engine oil to the new O-ring seal prior to installation.
  5. To install, reverse the removal procedure.
    • Install a new O-ring seal.
scientia non olet · About LEMON Manuals