Turbine Shaft Speed (TSS) Sensor and Intermediate Shaft Speed Sensor: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Install the TSS and intermediate shaft combination speed sensor.
1. Lubricate the O-ring with clean transmission fluid and install the TSS and intermediate shaft combination speed sensor.
2. Install the bolt.
  - Tighten to 9 Nm (80 lb-in).

Fig 1: Identifying Intermediate Shaft And Turbine Shaft Speed (TSS) Sensor

GF0006803

Courtesy of FORD MOTOR CO.

Connect the TSS and intermediate shaft combination speed sensor electrical connector.

Fig 2: Identifying Intermediate Shaft And Turbine Shaft Combination Speed Sensor Electrical Connector

G03889065

Courtesy of FORD MOTOR CO.

Raise the transmission and crossmember in position.
Install the LH crossmember bracket.

Fig 3: Locating LH Crossmember Bracket

G03889062

Courtesy of FORD MOTOR CO.

Install the 2 LH crossmember bracket nuts.
- Tighten to 81 Nm (60 lb-ft).

Fig 4: Identifying LH Crossmember Nuts

G03889061

Courtesy of FORD MOTOR CO.

Install the RH crossmember bracket.

Fig 5: Identifying RH Crossmember Bracket

G03889064

Courtesy of FORD MOTOR CO.

Install the 2 RH crossmember bracket nuts.
- Tighten to 81 Nm (60 lb-ft).

Fig 6: Identifying RH Crossmember Nuts

G03889063

Courtesy of FORD MOTOR CO.

Install the wire harness and install the 2 retaining clips to the rear of the crossmember.

Fig 7: Identifying Wire Harness Retaining Clips

G03889060

Courtesy of FORD MOTOR CO.