LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1112 (Instrument Cluster (Ic), Message Center, And Warning Chimes) >> Diagnostic Tests >> Instrument Cluster (IC) and Warning Chimes >> Pinpoint Tests >> Pinpoint Test W: The Traction Control/Stability Assist Indicator Is Never/Always On >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

The traction control/stability assist indicator flashes when the vehicle traction control or roll stability assist system is in active mode or is being controlled by the ABS module (roll stability assist) or the PCM (traction control). The instrument cluster (IC) receives the traction control/stability assist signal from the ABS module (roll stability assist) or the PCM (traction control) through the high speed controller area network (HS-CAN) communication bus. The instrument cluster (IC) monitors the traction control/stability assist signal and, when the ABS module (roll stability assist) or the PCM (traction control) detects a concern, the instrument cluster (IC) illuminates the traction control/stability assist indicator.

This pinpoint test is intended to diagnose the following:

scientia non olet · About LEMON Manuals