LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1110 (Supplemental Inflatable Restraint System) >> Diagnostic Tests >> Air Bag and Safety Belt Pretensioner Supplemental Restraint System (SRS) >> Principles of Operation >> Impact Sensors

Impact Sensors

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: If a vehicle has been in a crash, inspect the restraints control module (RCM) and the impact sensor (if equipped) mounting areas for deformation. If damaged, restore the mounting areas to the original production configuration. A new RCM and sensors must be installed whether or not the air bags have deployed. Failure to follow these instructions may result in serious personal injury or death in a crash.

For this vehicle line, the supplemental restraint system (SRS) uses one satellite sensor in addition to the restraints control module (RCM). The RCM is mounted beneath the driver seat. All vehicles have one front impact severity sensor located in the front-center area of the vehicle, behind the grille mounted on the lower radiator support. Mounting orientation is critical for correct operation of all impact sensors.