LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Exterior Lighting System) >> Removal And Installation >> Side Lamp/Front Turn Signal Lamp Bulb >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Aerodynamic style headlamp 

  1. Remove the headlamp assembly. For additional information, refer to Headlamp Assembly .

    2. Sealed beam style headlamp 

  2. Remove the 4 bolts and the side lamp/front turn signal lamp housing.
    • Disconnect the electrical connectors.

    3. All headlamp types 

  3. Rotate the bulb holder counterclockwise approximately one-eighth turn and remove it.
    • Separate the bulb from the bulb holder.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals