LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Exterior Lighting System) >> Diagnostic Tests >> Turn Signal and Hazard Lamps >> Pinpoint Tests >> Pinpoint Test K: One Turn Signal Lamp Is Inoperative/Always On >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

When the multifunction switch is placed in the LH or RH turn position, the multifunction switch correspondingly routes the voltage to the LH or RH turn lamps. The LH front turn lamp receives voltage through circuit 3 (LG/WH). The RH front turn lamp receives voltage through circuit 2 (WH/LB). Ground for the front turn lamps is provided through circuit 57 (BK).

The rear lamps are combination stop/turn lamps. The turn lamp functionality utilizes the existing stoplamp circuitry.

This pinpoint test is intended to diagnose the following:

scientia non olet · About LEMON Manuals