LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1101 (Body Panel System - Front End Body Panels) >> Removal And Installation >> Radiator Grille Support >> Installation

Radiator Grille Support: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the radiator grille supports and the radiator grille support screws.
    • Tighten to 6 Nm (53 lb-in).
  2. Attach the horn wiring harness to the RH radiator grille support.
    3. Fig 1: Locating Horn Wiring Harness
    GF0044420Courtesy of FORD MOTOR CO.
  3. Install the radiator grille support-to-power steering cooler screws.
    • Tighten to 6 Nm (53 lb-in).
    4. Fig 2: Locating Radiator Grille Support-To-Power Steering Cooler Screws
    GF0044419Courtesy of FORD MOTOR CO.
  4. Install the radiator grille support-to-transmission cooler screws.
    5. Fig 3: Locating Radiator Grille Support-To-Transmission Cooler Screws
    GF0044418Courtesy of FORD MOTOR CO.
  5. Install the lower radiator grille opening panel reinforcement. For additional information, refer to Radiator Grille Opening Panel Reinforcement - Lower .
  6. Tighten the radiator grille support-to-adjustment screws to 6 Nm (53 lb-in).
    7. Fig 4: Locating Radiator Grille Support-To-Adjustment Screws
    GF0044421Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals