LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1101 (Body Panel System - Front End Body Panels) >> Removal And Installation >> Radiator Grille Opening Panel Reinforcement - Upper >> Installation

Radiator Grille Opening Panel Reinforcement - Upper: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the radiator grille opening panel.
  2. Install the radiator grille opening panel retainer screws in the sequence shown.
    • Tighten to 9 Nm (80 lb-in).
    3. Fig 1: Installing Radiator Grille Opening Panel Retainer Screws In Sequence
    GF0044414Courtesy of FORD MOTOR CO.
  3. Install the upper air deflector. For additional information, refer to Air Deflector - Upper .
  4. Install the radiator grille. For additional information, refer to EXTERIOR TRIM AND ORNAMENTATION article.
scientia non olet · About LEMON Manuals