LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1101 (Body Panel System - Front End Body Panels) >> Removal And Installation >> Radiator Grille Opening Panel Reinforcement - Lower >> Installation

Radiator Grille Opening Panel Reinforcement - Lower: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the lower radiator grille opening panel reinforcement screws.
  2. Install the lower radiator grille opening panel reinforcement screws in the sequence shown.
    • Tighten to 9 Nm (80 lb-in).
    3. Fig 1: Installing Lower Radiator Grille Opening Panel Reinforcement Screws In Sequence
    GF0044416Courtesy of FORD MOTOR CO.
  3. Install the headlamps. For additional information refer to EXTERIOR LIGHTING article.
  4. Install the upper radiator grille opening panel reinforcement. For additional information, refer to Radiator Grille Opening Panel Reinforcement - Upper .
scientia non olet · About LEMON Manuals