LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1033 (Accessory Drive - 3.0L (4V)) >> Removal And Installation >> Accessory Drive Belt Tensioner >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the pin-type retainer, 5 bolts and the RH lower splash shield.
    • To install, tighten to 9 Nm (80 lb-in).
  3. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
  4. Remove the bolt and the accessory drive belt tensioner.
    • To install, tighten to 45 Nm (33 lb-ft).
    5. NOTE: Refer to the illustration for correct drive belt routing.
  5. To install, reverse the removal procedure.
    6. Fig 1: Identifying Drive Belt Routing
    GF0042197Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals