LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1009 (Interior Trim And Ornamentation) >> Removal And Installation >> Quarter Trim Panel >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the rear door scuff plate trim panel access cover and remove the rear door scuff plate trim panel pin-type retainer.
  2. Remove the rear door scuff plate trim panel.
  3. Remove the liftgate scuff plate.
    4. Fig 1: Identifying Liftgate Scuff Plate
    GF0041716Courtesy of FORD MOTOR CO.
  4. Position the liftgate weatherstrip aside.
  5. If equipped, remove the cargo net hold-down.
    6. NOTE: Insert a non-marring tool between the D-pillar trim panel and rear quarter trim panel to release the trim panel.
  6. Remove the rear quarter trim panel.
    7. Fig 2: Identifying Rear Quarter Trim Panel
    GF0041717Courtesy of FORD MOTOR CO.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals