LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1002 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Liftgate Release Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the liftgate trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  2. Remove the 4 liftgate trim bezel nuts and remove the bezel from the liftgate.
    • To install, tighten to 8 Nm (71 lb-in).
    • Disconnect the electrical connector.
    • Using the appropriate tool, press the tabs and remove the liftgate release switch.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals