LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel And Console >> Removal And Installation >> Storage Compartment - Upper >> Removal and Installation

Removal and Installation

  1. Remove the upper storage compartment tether nut.
    • To install, tighten to 6 Nm (53 lb-in).
    NOTE: Steering column shroud removed to show clarity.
    Fig 1: Locating Upper Storage Compartment Tether Nut
    G06271536Courtesy of FORD MOTOR CO.
  2. Remove the upper storage compartment mat and the 2 upper storage compartment screws.
  3. Remove the upper storage compartment in the following sequence.
    1. Pull the upper storage compartment toward the rear of the vehicle to release the 5 retaining clips.
    2. Disconnect the electrical connector, if equipped.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals