Removal and Installation

Remove the Motor Electronics Cooling System (MECS) expansion tank nut and bolt, position the tank aside.
- To install, tighten the nut and bolt to 12 Nm (106 lb-in).
Fig 1: Locating MECS Expansion Tank Nut & Bolt
Courtesy of FORD MOTOR CO.
Disconnect the brake booster vacuum sensor electrical connector.
Release the brake booster vacuum sensor retainer ring and remove the vacuum sensor.

Fig 2: Releasing Brake Booster Vacuum Sensor Retainer Ring
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
Following the scan tool instructions, carry out the Multi-Calibration Routine.