Removal and Installation

Fusion, Milan 

1. Remove the access cover and the screw.
2. Using an appropriate non-marring trim tool, pry the rear of the switch bezel upward and then shift the switch assembly rearward to disengage the front locking tab.
   Fig 1: Prying Rear Of Switch Bezel Upward

   Courtesy of FORD MOTOR CO.

   MKZ 

3. Using an appropriate non-marring trim tool, pry the rear of the switch bezel upward to disengage the retaining clip, then shift the switch assembly rearward to disengage the front locking tab.
   NOTE: For LH front window control switch assembly only, the rear retaining clip is located off-center towards the outside of the vehicle.

   All Vehicles 

4. Disconnect the electrical connector(s).
5. Remove the window control switch.
6. To install, reverse the removal procedure.