LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Removal And Installation >> Steering Column Multifunction Switch >> Removal and Installation

Removal and Installation

  1. Remove the steering column opening cover by pulling straight outward.
    NOTE: The steering column opening cover is held in place by tabs that clip to the instrument panel.
  2. Remove the upper steering column shroud.
    NOTE: Release the upper steering column shroud, by pressing inward on the sides of the shroud and lifting upwards.
  3. Release the tilt lever, remove the 3 lower steering column shroud screws and then the shroud.
  4. Disconnect the multifunction switch electrical connector.
  5. Remove the 2 multifunction switch screws and the switch.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals