Pinpoint Test I: The Tachometer Is Inoperative

I1 CARRY OUT THE TACHOMETER ACTIVE COMMAND USING THE SCAN TOOL

NOTE: On hybrid vehicles, verify that the IPC display mode is set to the enlighten mode setting before beginning diagnostics.

Select the IPC tachometer (TACH_IND) active command. Command the tachometer according to the following table while monitoring the tachometer.

NOTE: On hybrid, make sure to set the scan tool to 0 rpm before beginning this test.

TECHOMETER REFERENCE TABLE

Does the tachometer start at 0 rpm, move to 3,500 rpm, 7,000 rpm and then return to 0 rpm?

Yes : GO to I2.
No : INSTALL a new IPC . REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.

I2 RETRIEVE THE RECORDED DTCs FROM THE PCM KOEO SELF-TEST
- Check for recorded PCM DTCs from the Key ON Engine OFF (KOEO) self-test.
- Are any DTCs recorded?
- Yes : DIAGNOSE all PCM DTCs first. REFER to the INTRODUCTION - GASOLINE MODELS and INTRODUCTION -- HYBRID .
- No : GO to I3.
I3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Check for recorded DTCs from the IPC self-test.
- Are any DTCs recorded?
- Yes : For DTC U0100:00, Go To PINPOINT TEST BF .
  For DTC U0401:68, RETRIEVE and REPAIR all non-network DTCs in the PCM and other modules on the network. REFER to the INTRODUCTION - GASOLINE MODELS and INTRODUCTION -- HYBRID and MULTIFUNCTION ELECTRONIC MODULES for a list of all DTCs.
  
  For all other DTCs, REFER to DTC TABLES .
- No : INSTALL a new PCM. REFER to Refer to the appropriate Electronic Engine Controls article for the procedure. TEST the system for normal operation.