Clutch Slave Cylinder: Service and Repair

Clutch Slave Cylinder





Removal and Installation

WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.

1. Remove the transaxle. For additional information, refer to Manual Transmission/Transaxle.

2. Disconnect the clutch slave cylinder-to-clutch hydraulic fluid tube adapter.

3. Remove the 3 clutch slave cylinder bolts and the clutch slave cylinder.
- To install, tighten to 12 Nm (106 lb-in).

4. To install, reverse the removal procedure.
- Bleed the air from the system. For additional information, refer to Manual Transmission/Transaxle &/or Clutch, M/T.