Bumper - Rear, With Trailer Hitch

Bumper - Rear, With Trailer Hitch

1. Remove the rear bumper cover. For additional information, refer to Bumper Cover - Rear Removal and Replacement.

2. Remove the 2 trailer hitch-to-back panel bolts.
- To install, tighten to 40 Nm (30 lb-ft).

3. Remove the 2 trailer hitch-to-back panel nuts.
- To install, tighten to 40 Nm (30 lb-ft).

4. Remove the 4 trailer hitch-to-body bolts.
- To install, tighten to 175 Nm (129 lb-ft).

5. Remove the trailer hitch.
- Disconnect the electrical connector from the trailer hitch.

6. To install, reverse the removal procedure.