LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Sable Premier, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1871 (Engine Controls - Pinpoint Test JF: Integrated Ignition Coil On Plug Coils A Through J Failure Through Pinpoint Test Kn: Variable Speed Electric Cooling Fan - (Except Diesel & Hybrid)) >> Pinpoint Test KA: Fuel Pump (FP) Relay >> Introduction

Pinpoint Test KA: Fuel Pump (FP) Relay: Introduction

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2009 Mercury Mountaineer, 2009 Mercury Milan, 2009 Mercury Mariner, 2009 Mercury Grand Marquis, and 2009 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

This pinpoint test is intended to diagnose the following:

The VPWR and FP circuits may be reversed in the harness connector. Refer to the appropriate SYSTEM WIRING DIAGRAMS article for schematic and connector information.

Fig 1: Fuel Pump (FP) Relay Connector
G06054045Courtesy of FORD MOTOR CO.
Fig 2: Inertia Fuel Shutoff (IFS) Switch Connector
G06054046Courtesy of FORD MOTOR CO.

For PCM connector views or reference values, refer to REFERENCE VALUES .

POWERTRAIN CONTROL MODULE (PCM) CONNECTOR

Vehicle Connector Pin Circuit
Focus 190-Pin B32
B19
FPM
FP
Fusion,
Milan,
MKZ
140 Pin B30
B62
FPM
FP
Ranger 170 Pin B21
B12
FPM
FP
All other vehicles 190-Pin B30
B62
FPM
FP