DTC P1451: - Evaporative Emission System Vent Control Circuit
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2009 Mercury Mountaineer, 2009 Mercury Milan, 2009 Mercury Mariner, 2009 Mercury Grand Marquis, and 2009 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
DTC P1451: - EVAPORATIVE EMISSION SYSTEM VENT CONTROL CIRCUIT
| Description: | Monitors the canister vent (CV) solenoid circuit for an electrical failure. The test fails when the signal moves outside the minimum or maximum allowable calibrated parameters for a specified canister vent duty cycle by powertrain control module (PCM) command. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | To verify normal functioning, monitor the evaporative emission (EVAP) CV solenoid signal PID EVAPCV and the signal voltage on the PCM control side. With the valve open, the EVAPCV PID indicates 0% duty cycle and a voltage approximately equal to battery voltage. When the valve is commanded fully closed, the EVAPCV PID indicates 100% duty cycle, and a minimum voltage drop of 4 volts is normal. Output test mode (OTM) may be used to switch the output on and off to verify function. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to Pinpoint Test HX . | ||