DTC P0704: - Clutch Switch Input Circuit
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2009 Mercury Mountaineer, 2009 Mercury Milan, 2009 Mercury Mariner, 2009 Mercury Grand Marquis, and 2009 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0704: - CLUTCH SWITCH INPUT CIRCUIT
| Description: | When the clutch pedal is applied the voltage goes to low. If the powertrain control module (PCM) does not see this change from high to low the DTC is set. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | When the clutch pedal is applied and then released, the switch voltage should cycle. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to Pinpoint Test TA . | - | GO to Pinpoint Test TA . |