LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Automatic Transmission - (Hybrid)) >> In-Vehicle Repair >> Transmission Insulator and Retainer - Upper >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove the Air Cleaner (ACL) assembly. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING - HYBRID .
  2. Install the Engine Support Bar, Support Leg Adapter, Engine Support Bar Adapter and Lifting Hook Adapter.
    Fig 1: Lifting Engine
    G06097859Courtesy of FORD MOTOR CO.
  3. Remove the upper insulator bracket bolts and the bracket.
    • To install, tighten to 25 Nm (18 lb-ft).
    Fig 2: Locating Upper Insulator Bracket Bolts
    G06097860Courtesy of FORD MOTOR CO.
  4. Remove the upper insulator.
    1. Remove the upper insulator nuts.
      • To install, tighten to 90 Nm (66 lb-ft).
    2. Remove the upper insulator through bolt.
    • To install, tighten the bolt to 103 Nm (76 lb-ft).
    Fig 3: Locating Upper Insulator Nuts
    G06097861Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals