Removal and Installation

WARNING: This page is about a different variant/trim than selected.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the rear insulator through bolt.
- To install, tighten to 115 Nm (85 lb-ft).
Fig 1: Locating Rear Insulator Through Bolt
Courtesy of FORD MOTOR CO.
Remove the rear insulator nuts and bolt.
- To install, tighten to 80 Nm (59 lb-ft).
Fig 2: Locating Rear Insulator Nuts And Bolt
Courtesy of FORD MOTOR CO.
Remove the rear insulator studs.
- To install, tighten to 12 Nm (106 lb-in).
Fig 3: Locating Rear Insulator Studs
Courtesy of FORD MOTOR CO.
Remove the rear insulator.

Fig 4: Locating Rear Insulator
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.