DTC P2802: Transmission Range Sensor B Circuit Low
WARNING: This page is about a different variant/trim than selected.
P2802: TRANSMISSION RANGE SENSOR B CIRCUIT LOW
| Description: | The powertrain control module (PCM) checks the gear selector position by monitoring three independent voltage signals from the transmission range (TR) sensor. The TR voltages are then compared to an allowed voltage range for each gear. The test fails when the compared voltages are out of range. This DTC indicates that one TR signal is low. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | See the diagnostic aids for DTC P2800. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST TA . | ||