DTC P1A08: Generator Mode Signal
WARNING: This page is about a different variant/trim than selected.
P1A08 - GENERATOR MODE SIGNAL
| Description: | The transaxle control module (TCM) continuously monitors the controller area network (CAN) communication bus for a generator mode message from the powertrain control module (PCM). This DTC sets when the received message does not match the actual generator mode. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Monitor the GENMODE PID. The PID state ERROR indicates a hardware concern. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST TI . | - | GO to PINPOINT TEST TI . |