DTC P1145 (TCM): Calculated Torque Error
WARNING: This page is about a different variant/trim than selected.
P1145 (TCM) - CALCULATED TORQUE ERROR
| Description: | The transaxle control module (TCM) continuously monitors the controller area network (CAN) for calculated torque message from the powertrain control module (PCM). This DTC is set when the calculated torque is not within the expected range. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Monitor the TCM TQ_DSD PID. The PID value should be positive in DRIVE or LOW, negative in REVERSE, 0 Nm (0 lb ft) in PARK or NEUTRAL if the brake pedal is not applied. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST TU . | - | GO to PINPOINT TEST TU . |