DTC P013A: O2 Sensor Slow Response - Rich To Lean (Bank 1, Sensor 2)
WARNING: This page is about a different variant/trim than selected.
P013A: O2 SENSOR SLOW RESPONSE - RICH TO LEAN (BANK 1, SENSOR 2)
| Description: | During a deceleration fuel shut-off (DFSO) event, the powertrain control module (PCM) monitors how quickly the rear heated oxygen sensor (HO2S) switches from rich to lean. The measured rate of the rich to lean switch is compared to a calibrated fault threshold value. The threshold value takes into account the level of oxygen in the catalyst, which has an impact on how quickly the rich to lean switch occurs. The test fails when the measured value is slower than the threshold value. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Check for leaks in the exhaust system. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | - | - | GO to PINPOINT TEST DW . |