DTC P0012: Intake Camshaft Position Timing - Over-Retarded (Bank 1)

WARNING: This page is about a different variant/trim than selected.

P0012 - INTAKE CAMSHAFT POSITION TIMING - OVER-RETARDED (BANK 1)

Description:	The powertrain control module (PCM) monitors the variable camshaft timing (VCT) position for over-retarded camshaft timing. The test fails when the camshaft timing exceeds a maximum calibrated value or remains in a retarded position.
Possible Causes:	Camshaft timing incorrectly set Continuous oil flow to the VCT piston chamber VCT solenoid valve stuck open Camshaft advance mechanism binding (VCT unit)
Diagnostic Aids:	This DTC is a functional check of the VCT unit. Diagnose any base engine concerns related to the engine oil pressure or engine timing. Refer to ENGINE SYSTEM-GENERAL INFORMATION , Oil Pressure Test, to check the engine oil pressure. Refer to ENGINE - 2.5L , Timing Drive Components, to check the engine timing.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	-	GO to PINPOINT TEST HK .	GO to PINPOINT TEST HK .