DTC P0010: Intake Camshaft Position Actuator Circuit/Open (Bank 1)
WARNING: This page is about a different variant/trim than selected.
P0010 - INTAKE CAMSHAFT POSITION ACTUATOR CIRCUIT/OPEN (BANK 1)
| Description: | The powertrain control module (PCM) monitors the variable camshaft timing (VCT) circuit to the PCM for high and low voltage. The test fails if the voltage exceeds or falls below a calibrated limit for a calibrated amount of time. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | This DTC is a circuit check. Testing should include the harness and solenoid coil. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST HK . | ||