TR Sensor and PCM Interface

WARNING: This page is about a different variant/trim than selected.

The TR sensor is a linear potentiometer device that provides the PCM with a percentage of input voltage proportional to the rotational angle of the sensor shaft. The TR sensor consists of:

two independent (TR-A1 and TR-A2) signals
two 5 volt reference (TR-VREF1 and TR-VREF2) lines
two signal return (TR-RTN1 and TR-RTN2) lines

The TR-A1 signal has a negative voltage slope, meaning the voltage decreases when the sensor angle increases. The typical TR voltage ranges from approximately 4.3 volts in the PARK position to approximately 0.6 volt in the LOW gear position. The TR-A2 signal has a positive voltage slope. Voltages increase as the sensor angle increases. The typical voltage for the TR-A2 is about 1 volt in the PARK position to about 4.4 volts in the LOW gear position.

The TR-VREF circuits are bussed together internal to the TR sensor, and both TR-RTN circuits are bussed together in the TR sensor. One of the TR-VREF and one of the TR-RTN circuits are dedicated signals from the PCM. This design of redundant signals protects against an open circuit condition.