Clear The Continuous Diagnostic Trouble Codes (DTCs) In The Transaxle Control Module (TCM): Description
WARNING: This page is about a different variant/trim than selected.
NOTE:
Clearing the continuous DTCs in the TCM can be carried out only with the key in the ON position. It can not be carried out once the key is cycled to the START position.
Clearing the continuous DTCs in the TCM allows the scan tool to command the TCM to clear all DTCs along with freeze frame information.
The following events occur when the continuous DTCs are cleared in the TCM:
- the number of DTCs are cleared
- the DTCs are cleared
- the freeze frame data is cleared