Test Procedure

WARNING: This page is about a different variant/trim than selected.

TQ1 DIAGNOSTIC TROUBLE CODE (DTC) P2806: CHECK THE FUNCTION OF THE GEAR SELECTOR

Key ON, engine OFF.
Move the gear selector lever from PARK to REVERSE, NEUTRAL, DRIVE, and LOW gears.

Does the gear selector indicator on the instrument cluster match the position of the gear selector lever?

Yes	No
GO to TQ2.	REFER to AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS and diagnose the shift control is out of correct relationship condition.

TQ2 CHECK GEAR SELECTOR LEVER CABLE ALIGNMENT

NOTE: This step checks if the gear selector lever aligns with the drive position rib on the transaxle case.

Key ON, engine OFF.
Gear selector in DRIVE position.
Visually check if the gear selector lever aligns with the drive position rib on the transaxle case. Refer to AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS , for the alignment procedure.

Does the gear selector lever align with the drive position rib on the transaxle case?

Yes	No
GO to TQ3.	REFER to AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS to align the gear selector lever.

TQ3 CHECK THE GEAR SELECTOR LEVER CABLE AND BRACKET

Is a concern present?

Yes	No
REPAIR as necessary. CLEAR the DTCs. REPEAT the self-test.	GO to TQ4.

TQ4 CHECK THE PARK PAWL FUNCTION

Place the vehicle on a slight grade with the gear selector in PARK with the brake applied.
Release the brake pedal.

Does the park pawl keep the vehicle from moving when the brake is released?

Yes	No
Unable to duplicate or identify the concern at this time. RETURN to SYMPTOM CHARTS to continue diagnosis.	INSTALL a new transaxle assembly. REFER to AUTOMATIC TRANSAXLE/TRANSMISSION - ELECTRONICALLY CONTROLLED CONTINUOUSLY VARIABLE TRANSMISSION (ECVT) .