LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 28 (Evaporative Emissions System - (Hybrid)) >> Removal And Installation >> Evaporative Emission Canister Vent Solenoid >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
  1. Remove the Evaporative Emission (EVAP) canister assembly. For additional information, refer to EVAPORATIVE EMISSION CANISTER .
  2. Disconnect the EVAP canister vent solenoid and fuel vapor vent valve electrical connectors, release the pin-type retainer and remove the EVAP canister wire harness.
  3. Remove the 3 EVAP canister tray bolts.
    • To install, tighten to 5 Nm (44 lb-in).
  4. Disconnect the EVAP canister purge tube-to-EVAP canister quick connect coupling. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .
  5. Disconnect the fuel vapor vent valve-to-EVAP canister quick connect coupling. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .
  6. Remove the EVAP canister from the tray.
  7. Depress the locking tab outward, rotate the EVAP canister vent solenoid clockwise and remove it from the EVAP canister.
    8. NOTE: Do not apply oil to the EVAP canister O-ring seal. Clean water may be applied to aid reassembly.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals