Removal and Installation

WARNING: This page is about a different variant/trim than selected.

Remove the ignition coils. For additional information, refer to IGNITION COIL-ON-PLUG .

NOTE: Only use hand tools when removing or installing the spark plugs, or damage can occur to the cylinder head or spark plug.

NOTE: Use compressed air to remove any foreign material in the spark plug well prior to removing the spark plugs.

Remove the spark plugs.
- To install, tighten to 15 Nm (133 lb-in).
Inspect the spark plugs. For additional information, refer to ENGINE SYSTEM-GENERAL INFORMATION .
To install, reverse the removal procedure.
- Adjust the gap as necessary.
  
  Fig 1: Identifying Spark Plug Gap
  Courtesy of FORD MOTOR CO.