LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - 2.5L - (Hybrid)) >> In-Vehicle Repair >> Engine Mount >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the engine coolant degas bottle. For additional information, refer to ENGINE COOLING - HYBRID .
  3. Remove the DC/DC converter. For additional information, refer to HIGH VOLTAGE CONVERTER/INVERTER .
  4. Install the Engine Support Bar.
    Fig 1: Identifying Engine Support Bar
    G06095022Courtesy of FORD MOTOR CO.
  5. Remove the engine mount bracket bolt.
    • To install, tighten to 115 Nm (85 lb-ft).
  6. Use the Engine Support Bar to raise the engine 25 mm (0.98 in).
    Fig 2: Identifying Engine Support Bar
    G06095022Courtesy of FORD MOTOR CO.
  7. Remove the 3 nuts and the engine mount bracket.
    • To install, tighten to 115 Nm (85 lb-ft).
  8. Remove the A/C tube bracket nut.
    • To install, tighten to 10 Nm (89 lb-in).
  9. Rotate the A/C tube brackets off of the studs.
    • Reposition the A/C tubes to access the engine mount bolt.
  10. Remove the 3 bolts and the engine mount.
    • To install, tighten to 48 Nm (35 lb-ft).
  11. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals