LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - 2.5L - (Hybrid)) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Removal

Crankshaft Rear Seal: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the flywheel. For additional information, refer to FLYWHEEL .
  3. Drain the engine oil.
    • Install the drain plug.
    • Tighten to 28 Nm (21 lb-ft).
    4. NOTE: If the oil pan is not removed, damage to the rear oil seal retainer joint can occur.
  4. Remove the 17 bolts and the oil pan.
  5. Remove the 6 bolts and the crankshaft rear oil seal with retainer plate.
scientia non olet · About LEMON Manuals