LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Valve Spring, Retainer, and Seal >> Installation

Valve Spring, Retainer, and Seal: Installation

WARNING: This page is about a different variant/trim than selected.
    NOTE: Lubricate the valve guide with clean engine oil.
    Fig 1: Installing Valve Seal
    G06095599Courtesy of FORD MOTOR CO.
  1. Using the Valve Stem Oil Seal Installer, install the valve seal.
  2. Using the Valve Spring Compressor, install the valve spring, retainer and key.
    Fig 2: Identifying Valve Spring, Retainer And Key
    G06095597Courtesy of FORD MOTOR CO.
  3. Install the camshaft roller followers. For additional information, refer to CAMSHAFT ROLLER FOLLOWER .
scientia non olet · About LEMON Manuals